A fast monsoon storm can knock out power for a Phoenix-area home in the hottest part of the year, and a generator is one way to cover the gap. This guide compares standby and portable units, and explains the safety and wiring steps that matter more than the brand.
Why monsoon outages push people toward generators
APS says power outages from fast-moving monsoon storms can and do occur, and monsoon season runs from June 15 through September 30. In the Valley that window overlaps with the hottest weeks of the year, so an outage is more than an inconvenience. Air conditioning stops, refrigerated food warms and anyone who relies on powered medical equipment is at risk. Arizona DHS advises people to limit time in the heat during an outage, drink plenty of water, check on neighbors and call 9-1-1 for signs of heat stroke.
Before buying anything, decide what you need to keep running. A few lights, a refrigerator and a phone charger are a small job. Running a central air conditioner is a very different one, and that difference drives the choice between a portable and a standby generator. Electrician Phoenix is a free referral service, not an electrical contractor, and the independent local electricians it connects you with can size the job against your actual panel and meter.
Portable generators: what they do well and where they fall short
A portable generator is a gas-powered unit you roll out when the lights go off. It costs less up front than a standby system, needs no permanent installation and can be used elsewhere, such as at a campsite. The trade-offs are real, though.
- You must be home to start it, fuel it and move it into place, often in wind and dust.
- Stored fuel ages, and a unit that sat in a hot garage all summer may not start when needed.
- Extension cords feed individual items only. Most portable units cannot run a whole home or a central air conditioner without a proper connection.
- Carbon monoxide is the biggest hazard, covered in the next section.
If you go the portable route and want to power circuits in the house instead of trailing cords, the safe method is a manual transfer switch or an interlock kit installed by an electrician, with an inlet box on the outside wall. Never wire a generator to a dryer outlet with a homemade double-ended cord.
Carbon monoxide and placement
The Consumer Product Safety Commission says portable generators belong outdoors, far from the home and away from windows, doors and vents. It says never to run one in a garage, even with the door open. Carbon monoxide has no smell, and a Phoenix garage with an open door still lets the gas drift into the house. Many people try to keep a generator out of the sun and rain by tucking it near the house wall, which is exactly the wrong spot. Plan for a shaded, open area at a distance, on level ground, with the exhaust pointed away from the building. Battery-powered carbon monoxide alarms inside the home are an inexpensive backstop, and our smoke detector installation page covers alarm placement.
Backfeed: the danger to utility workers
If a generator is connected to household wiring without a transfer switch or interlock, power can flow backward through the meter onto the utility's lines. SRP describes backfeed as electricity flowing from a home generation source onto its grid, and calls it a serious safety hazard during an outage. A line worker who believes a street is dead can be hurt or killed. APS says an inverter or generator that connects to its system needs a separate interconnection application, which is a different matter from an isolated backup unit, but the principle is the same: the home must be cleanly separated from the grid when the generator runs.
A transfer switch does that separation. It physically prevents the generator and the utility from feeding the same wiring at once. This is not a place for improvisation, and it is a good reason to hire an electrician for the connection even if you buy the generator yourself. If you plan to attach solar or a battery, say so up front, because those systems have their own utility rules.
Standby generators: a permanent system
A standby generator sits outside the house on a pad, connects to natural gas or propane and starts on its own when the utility power drops. An automatic transfer switch handles the separation described above. Standby units suit homes where an outage is a health or comfort risk, or where nobody is reliably home to run a portable one.
What a standby installation involves:
- A load calculation, so the generator is sized for the circuits you want to back up, including the air conditioner.
- A pad location that meets clearance rules from the manufacturer and the local building office.
- A gas line, which usually means a separate plumbing or gas trade and a utility or tank arrangement.
- An automatic transfer switch wired into the main panel or a sub-panel.
- A permit and inspection where the local office requires them.
Arizona 811 says to contact it at least two full working days before digging, by visiting Arizona811.com or calling 811. That applies to the trench for a gas line or a buried electrical feed to the pad. Ask your electrician who places the 811 request.
What it costs
National cost guides give a very wide range. HomeAdvisor lists a whole-house generator installed at about $1,538 to $8,821 for most homeowners. That is a national figure, not a Phoenix quote. The low end tends to reflect smaller units, and the high end reflects larger standby systems, longer gas runs and added panel work. Portable generators and transfer switches sit well below standby systems, but no row in our cost data covers them, so ask the electrician for a written number. For comparison across other jobs, see our Phoenix electrician cost breakdown.
Portable or standby: a quick way to decide
| Question | Leans portable | Leans standby |
|---|---|---|
| Who needs power? | A fridge, lights, phones | Central AC, medical equipment, a full household |
| Is someone usually home? | Yes | Not always |
| Budget | Lower up front | Higher up front |
| Upkeep | Fresh fuel, test runs | Periodic service |
| Permit needs | Usually only the inlet or switch work | Pad, gas and transfer switch work |
Permits, inspections and the ROC check
A transfer switch, interlock or standby installation changes the home's wiring, and that generally means a permit from the city or county office that serves your address. The City of Phoenix Planning and Development Department lists work that adds to or modifies premises wiring as permit work, but its published documents do not address generators specifically, so ask the office before assuming. Other Valley towns run their own offices, listed on our service area pages, and our guide to which jobs need a permit shows how the offices differ.
Check the contractor too. The ROC says any project that requires a local permit is not exempt from an ROC license, regardless of cost. A contractor who holds an ROC license for residential electrical work uses class R-11, or CR-11 for both scopes, and the lookup on roc.az.gov is free. Our walkthrough of hiring an electrician in Arizona shows the steps.
Prepare the house, not just the generator
A generator does little good if the rest of the setup is weak. A few preparation steps are worth doing before the next storm:
- Secure loose items such as umbrellas and trampolines, which APS says can blow into power lines.
- Know how to open an automatic garage door by hand.
- Keep an emergency kit, and register with the APS Medical Preparedness Program if you rely on life-support equipment that needs electricity.
- After power returns, turn lights and appliances back on gradually. SRP advises switching them off during an outage so a surge does not occur at restoration, and APS suggests unplugging unneeded equipment.
Surges at restoration can damage electronics, so ask about whole-home surge protection at the same visit. If the home has a small older panel that cannot take a transfer switch or the added loads, a panel upgrade may come first, and the general facts on summer loads are in our summer heat guide.
Who to call during an outage
A generator does not change who to call. If a line is down, stay about 100 feet away, call 911, then call your utility. APS outages go to 602-371-3680 or 855-688-2437. SRP outages go to (602) 236-8888. Check your bill to see which utility serves you, and read our APS and SRP outage guide for the full picture. If you smell smoke or burning, leave and call 911 before anything else. When you are ready for the installation itself, the generator installation service page explains how the job goes, and an emergency electrician is the right call if a generator hookup has gone wrong.
Frequently asked questions
Can I run a portable generator in my garage if the door is open?
Do I need a transfer switch?
Does a generator installation need a permit?
How much does a whole-house generator cost?
Can a generator run my central air conditioner?
Sources
- APS: As monsoon season begins, APS offers ways to prepare and stay safe
- APS: Before Monsoon Season Arrives, Plan Ahead and Prepare
- CPSC: Generators and Engine-Driven Tools
- SRP: Solar energy system FAQ
- SRP: Outages and storms
- Arizona DHS: Power outages in extreme heat
- APS: Contact us
- HomeAdvisor: How Much Does a Whole-House Generator Cost?
- City of Phoenix: Electrical permit requirements
- Arizona ROC: Contracting in Arizona
Last updated: