Smoke alarms wear out and should be replaced on the manufacturer's schedule, not just when they chirp. The date is printed on the back of the unit. Call the number on this page to be connected with a local electrician in Tempe.

Do you have carbon monoxide protection?
Smoke alarms do not detect carbon monoxide. Homes with gas appliances, a fireplace or an attached garage should have CO alarms as well. Combination units cover both, and an electrician can place them correctly, since CO alarms are mounted differently from smoke alarms in many homes.
Newer homes, aging alarms
Builders wire interconnected alarms into newer houses, but those alarms still reach the end of their lives. When the date has passed, the old units come out and matching ones go in, usually without new wiring, since the existing bases and interconnect wires are already in place.
Homes from the 1980s were built before today's expectations for alarms in every bedroom, so adding units is a common request in this area.
Some Tempe streets are served by APS and others by SRP; either way, alarm wiring is inside the house and is an electrician's work.
Before electrical work starts in Tempe
Depending on the street, a Tempe home may be on APS or SRP. APS lists 602-371-3680 for outages.
Safety comes first: a burning smell, smoke or sparks from wiring means leave the house and call 911. A downed line is the utility's job, never an electrician's; keep 100 feet back, call 911 and then report it to the utility.
Permitted electrical work in Tempe is inspected by Tempe Building Safety. The contractor normally applies and schedules the inspection.
In Arizona, electrical contractors need a license from the Registrar of Contractors (ROC). Residential electrical work falls under the R-11 class, and the ROC's online contractor search shows whether a license is active.
Electricians who take calls here often also work in Mesa, Paradise Valley and Gilbert.
What shapes the cost of installation
The number of alarms, whether they are wired new or swapped into existing bases, and how easily cable can reach each location. Replacing like-for-like alarms is a small job. Wiring new ones through finished ceilings and attics takes longer.
Typical steps
- Walk through and count existing alarms.
- Confirm placement and type for each room.
- Turn off power and swap or install units.
- Connect interconnect wiring where needed.
- Restore power, test and label dates.
Ask to be shown each step if you want to understand how the alarms are wired.
Burning smells with no alarm
If you smell burning from an outlet, switch or panel, leave the house and call 911 first, even if no alarm sounds. Electrical faults can smolder inside walls before smoke reaches a detector. Alarms are one layer of protection, not the only one, and noses count too.
Tempe at a glance
Calls come in from across Tempe, including around Interstate 10, US 60, Loop 101.
Smoke Detector Installation questions in Tempe
What does interconnected mean?
Do alarms work during a power outage?
Are ionization or photoelectric alarms better?
Do landlords have to provide smoke alarms?
More electrical services in Tempe
Smoke Detector Installation nearby
Helpful guides
Sources
Last updated: